How do you mount tile roof solar mounting brackets

  • Browse 2311

It is not hard to learn how to mount tile roof solar mounting brackets on your tile roof. While you can hire an installation expert to do the work, it can be quite expensive. But it not difficult to install actually, so you can try after checking this article. A homeowner can save a lot of money by doing the installation work on his or her own.

How do you mount tile roof solar mounting brackets

Before the installation, here are some installation way you can refer to. You can install the panels flush on the roof, or install them at an angle or install a adjustable roof mount device first and then install the panels on this device. The last option is the best, as it enables a homeowner to adjust the angle so that the panels will always get as much sun as possible.

Next, you will need to determine where you want your solar panels installed. In order to get the most out your panels, you will need to install them on the part of the roof that gets the most sunlight. You will want to install them facing towards the east, as the sun rises in the east. If there are trees blocking the sun from hitting the eastward side of the roof, then these should be trimmed back.

The panels must be attached to the rafters so that they will remain steady and in place. Once you have found the rafters using either a laser light or stud finder, you will want to make a chalk marking to note where each mount should be placed. A person will then need to pre-drill the hole. Be very careful as you do this, as you do not want the rafters to crack or break. After drilling, you can move your tiles and put your tile roof solar brackets on the marked place, then fasten the hooks onto the rafter with the bolts. But if your brackets be blocked by the tile roof, you may need to cut a hole into the tile so that the tile can be properly fitted over the mounting bracket. The area would then need to be sealed with tar. After the brackets installation, you should check if all the brackets be mounted properly and ensure its stability.

After finishing the tile hooks installation, you can install the rails and solar panels. Kindly noted that you may need to connect two rails with rail splices connection kits if the rail is not sufficient long.

A homeowner who has a solar panel battery should then connect it to the installed panels. Then, the only job that will need to be done is to connect the panels to the inverter. While solar panel installation is relatively straightforward, electrical wiring is not and one may want to have this aspect of the work done by a professional.

You will find that learning how to mount tile roof solar mounting brackets on your roof is time well spent, but you can also save lots of money. A person who wants to install his or her own solar system should start with purchasing easy installed solar brackets.

Ready to discuss your solar project?
Click to submit your solar mounting system project information, we will contact you as soon as possible.
Enquiry
Online Enquiry
Submit your information, we will contact with you as soon as possible.
Xiamen Mibet New Energy Co., Ltd.
Address:No. 45 Sushan Road, Jimei District, Xiamen, China. 361024 Fax:+86-592-6771575
FOLLOW US
Tel:+86-592-3754999 Email:sales@mbt-energy.com Afters-sales service:service@mbt-energy.com
Top